Anritsu 37xxxE 37xxxE OM 7-41

Step 11. When menu C18A (left) appears, make the following
selections (for 2-line):
a. Move the cursor to DEVICE 1 LINE 1 (REF)
and key in the value.
b. Move the cursor to DEVICE 2 LINE/MATCH.
Here you have another decision to make:
whether your calibration is to be LRL or LRM.
For this selection, the Enter key acts as a toggle.
c. If you toggle such that LINE turns red, then
key in the value for line 2. This value depends
on your frequency range.
d. If you toggle MATCH red, observe that
FULLBAND appears. This indicates that your
reflective device covers the full calibration
range.
e. When you have made both selections, move the
cursor to NEXT CAL STEP and press the Enter
key to produce the next menu. Skip to Step 13.
37xxxE OM 7-41
MEASUREMENT CALIBRATION LRL/LRM CALIBRATION
MENU C18A
CHANGE LRL/LRM
PARAMETERS
NEXT CAL STEP
CHARACTERIZE
CAL DEVICES
DEVICE 1
LINE 1 (REF)
X.XXXX mm
DEVICE 2
LINE /MATCH
X.XXXX mm
PRESS <ENTER>
TO SELECT
OR SWITCH