Avaya 580, 882 Setting the System Clock

Document No. 10-300077, Issue 2 3-11
Configuring System Information
CLI Command To set Summer Time Hours that are not based on a standard rule using the
CLI, enter the following command from Configure mode:
(configure)# clock summer-time date
Setting the System Clock
The system clock is used for setting traps, alarms, and other events on the
switch.
* Note: You must set SNTP and Summer T ime Hours befo re you can set
the system clock. See “Enabling the Simple Network Time
Protocol” and “Setting Summer Time Hours” earlier in this
chapter.
* Note: The system clock does not automatically change with Daylight
Savings Time.
You can set the system clock from either the Web Agent or the CLI.
Web Agent
Procedure To set the system clock using the Web Agent:
1. In the navigation pane, expand the System > Configuration folders, and
then click System Clock. The System Clock Web page is displayed in
the content pane. See Figure3-6.
Start S pecifies the start of Summer Time Hours.
End Specifies the end of Summer Time Hours.
Table 3-2. One-Time Summer Time Hours Configuration
Parameter Definition
2 of 2