20-30 User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 20
Enabling the LGMP Client
You can enable the LGMP client statis tics usi ng either the Web Agent or the
CLI.

Web Agent

Procedure To enable an LGMP client using the Web Agent:
1. In the navigation pane, expand the L2 Switching > Intelligent
Multicast folders, and then click LGMP Client.
The LGMP Client Configuration Web page is displayed in the content
pane. See Figure 20-14.
*Note: You must enable intelligent multicasting on a global basis
to activate LGMP client configuration.
2. Select Enable from the State field pull-down menu, if it is not already
displayed.
3. Select APPLY to complete the operation, or CANCEL to ignore the
operation.
CLI Command To enable an LGMP client usi ng the CLI, enter the following comm and
from Configure mode:
(configure)# set lgmp client enable
Viewing LGMP Clients Statistics
You can view LGMP clients statistics using either the Web Agent or the
CLI.

Web Agent

Procedure To view LGMP Client statistics using the Web Agent:
1. In the navigation pane, expand the L2 Switching > Intelligent
Multicast folders, and then click LGMP Client.
The LGMP Client Configuration Web page is displayed in the content
pane. See Figure 20-14.
2. See Table20-11 for an explanation of the LGMP Client Configuration
Web page parameters
3. Click CLEAR to clear the statistics, or REFRESH to refresh the
contents of the table.
CLI Command To view the LGMP client statistics, use the following CLI command:
> show lgmp client statistics