Avaya 580, 882 Enabling an Access List

13-12 User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 13
Enabling an Access List
You can enable an access list on the switch through the Web Agent and the
CLI.
When you enable an ACL, the switch:
■May change the maximum number of forwarding entries for IP
unicast traffic to improve the perform a nce of the switch. If the
maximum number of entries is set to :
—Less than 15,000, the switch automatically doubles the setting.
—Between 15,000 and 30,000, the switch changes the setting to
30,000.
—Greater than 30,000, the switch does not change the setting.
■Automatically sets hash mode for IP unicast traffic to SA-DA. This
setting improves the performance of the switch when an ACL is
enabled.
Web Agent
Procedure To enable an access list:
* Note: Before you can enable an access list, you must first configure
the access list. For information about configuring access lists,
see “Configuring Access Lists” earlier in this chapter.
1. In the navigation pane, expand the Routing > IP > Configuration
folders, and then click Access Control.
The IP Access Control Web page is displayed in the content pane. See
Figure 13-4.
Figure 13-4. IP Access Control Web Page