Document No. 10-300077, Issue 2 12-37
Configuring IP Routing
CLI Command To configure DVMRP globally using the CLI:

(configure)# router dvmrp

Neighbor Router
Timeout Interval Enter the time-out interval (in seconds) that a
neighbor stays up without confirmation. This is an
important method used to time-out old routes.
The valid range for this field is 10 to 50 seconds.
The default setting is 35 seconds.
Minimum Flash Update
Interval Enter the update interval (in seconds) between
flash updates. This represents the minimum time
between advertisements of the same route.
The valid range for this field is 5 to 20 seconds. The
default setting is 5 seconds.
Maximum Number of
Routes Enter the maximum number of routes for this
interface.
The valid range for this field is 10 to 20,000. The
default setting is 7,000.
Route Report Interval Enter the report interval (in seconds) that elapses
between delivery of DVMRP routing table updates.
The valid range for this field is 30 to 90 seconds.
The default setting is 60 seconds.
Route Replace Time Enter the amount of replace time (in seconds)
before which a route entry will be removed if it is
not refreshed.
The valid range for this field is 70 to 190 seconds.
The default setting is 140 seconds.
Route Hold Down Time Set the hold down time (in seconds) that the switch
reports unavailable routes with a metric of infinity.
The valid range for this field is 120 to 380 seconds.
The default setting is 120 seconds.
Prune Message Lifetime Enter the lifetime (in seconds) that a transmitted
upstream prune message persists.
The valid range for this field is 100 to 7,200
seconds. The default setting is 7,200 seconds.

Table 12-9. DVMRP Global Configuration Web Page Parameters

Parameter Allows you to...
2 of 2