25-24 User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 25
<dscp> The DSCP that you want to replace the DSCP
of the packet.
use-l2 Classifies traffic by the layer 2 priority of the
packet. If you enter use-l2, the switch ignores
the ACL rule priority and DiffServ priority.
deny Blocks the packet.
fwd1 | fwd2 | fwd3 | fwd4 |
fwd5 | fwd6 | fwd7 | fwd8 The priority that you want to set.
The number following the fwd specifies the
priority. The fwdx arguments are 1-based,
while the queue priorities are 0-based.
Consequently, the 1-based priorities are
converted to 0-based priorities by the QoS
features. For example, to specify a priority of
0, enter fwd1.
These keywords are retained from earlier
versions of software for backward
compatibility. The use-priority <priority>
keyword and argument serve the same
function.
<protocol-id> The ID of the protocol that you want to assign
a priority to. RFC791 defines the pro t ocol
IDs.
<source-ip-addr> The source IP address of the subnet that you
want to assign a priority to.
<source-wildcard> The inverse of a network mask. Enter a 32-bit
number in four-part, dotted decimal format.
Place ones in the bit positions that you want to
mask.
This parameter specifies a range of IP
address. For example, to specify all IP
addresses in the 10.10.70 subnet, enter
10.10.70.0 0.0.0.255.
any A source of 0.0.0.0 and a source-wildcard of
255.255.255.255
host <source-ip-addr> The source IP address that you want t o ass i gn
a priority to.
[{lt <port> | eq <port> | gt
<port> | range <port>
<port>}]
A source port or range of source ports that
pass between two hosts or switches using the
Transmission Control Protocol (TCP) or the
User Datagram Protocol (UDP).
Table 25-14. Keywords, Arguments, and OptionsKeyword, Argument or
Option Definition
2 of 3