Document No. 10-300077, Issue 2 3-17
Configuring System Information
Figure 3-10. P882 Cooling System Status Web Page
2. Check the Status column to ensure that all the i ndivi dual c omponents are
operational.
3. If a component’s status is non-operational, power down the switch and
contact a service representative to diagnose the failing unit.
CLI Command To display your switch ’s power sy stem statistics using the CLI, ente r the
following command from Configuration mode:
(configure)# show system fans
Performing a Reset
You can reset your switch from either the Web Agent or the CLI.
* Note: You must reset your switch after licensing an
80-Series modules.

Web Agent

Procedure To reset your switch using the Web Agent:
* Note: You can also reset your switch using the Module Reset button
located on the Supervisor module. See the Installation Sheet
that came with the Supervisor Module for details.
1. In the navigation pane, expand the System folder, and the n clic k System
Reset. The System Reset Page Web page is displayed in the content
pane. See Figure 3-11.