Document No. 10-300077, Issue 2 8-49
Configuring Ports
See Table 8 -11 for explanations of the keywords, arguments, and
options in this command.
The CLI displays a confirmation message if you successfully enable
NEDR for a port or range of ports. If no message displays, the port
information was invalid.
* Note: Occasionally, if you enable NEDR on a 10-Gigabit port, the
following error message is displayed:
Set port network-error-detection failed:
<10-Gigabit port number>.
NEDR is successfully enabled regar dless of the error message.
Ignore the error message.
3. To verify that NEDR is enabled on a port, enter the following CLI
command:
show port network-error-detection [<mod-port-range>]
If the port is not listed as enabled for NEDR, reenable NEDR on the
same port or ports again.
Table 8-11. Keywords, Arguments, and Options
Keywords, Arguments
and Options Explanation
<mod-port-range> The slot number of the module, and, either port
number, or range of port numbers. Enter the port
ranges in the format Px-Py. For example:
• To specify port 1 on the module in slot 3,
enter 3/1.
• To specify ports 1 through 5 on the module
in slot 3, enter 3/1-5.
all Disables NEDR on all ports on all modules in the
switch. all can be used only with off.
Note: The set port network-error-detection
all action off CLI command does not
turn off NEDR on 10-Gigabit ports. To
turn off network error detection for
specific 10-Gigabit ports, use the set
port network-error-detection <mod-
port-range> action off command.
1 of 2