14-8 User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 14
Key Chains on the Avaya Multiservice Switch
The Avaya Multiservice switch supports the creation of a single Key Chain
with a single Key. Hence, Key and Key Chain are interchangeable terms.
The Key has a setting for a start time and duration. Regardless of duration,
the Key’s start time must be set, even if the duration is set to infinity.
If the duration is less than 4294967295 seconds, the Key will expire.
Ironically, this number is approximately 136 ye ars. A more reali stic number
would be 18000 seconds (5 Hours). For this time interval, the RIP V2
interface would exchange routes with other RIP V2 routers in the same
subnet. Once expired, the RIP V2 interface would no longer accept RIP
packets from RIP V2 routers on that subnet.
If the Key’s duration is 4294967295 (alternately -1), the key never expires.
Again, if you use this value, you must still specify a Key Accept Time.
Failure to do so will result in the Avaya switch not creating the Key.
Configuring Key Chains

Web Agent

Procedure You can configure Key Chains using the Web Agent or the CLI.
To create a Key Chain/Key using the Web Agent:
1. In the navigation pane, expand the Routi ng > I P > RI P folders, and then
click Key Chain.
The Key Chain Web page is displayed in the content pane. See
Figure 14-5.