24-2 User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 24
The Service Ratio can be chosen to match traffic patterns and performance
requirements using a weighted round robin scheduling algorithm. The
available service ratios of the alg orithm are defined in “Managing Buffers
and Queues”. The factory default service ratio for f abr ic por ts is 999/1. The
factory default service ratio f or physical ports is 1023 to 1. If the re is traffic
to be serviced from both the high- and normal-priority queues, 999 packets
of high-priority traffic will be processed for each normal-priority packet.
When the high-priority queue fills up, incoming frames are dropped. The
philosophy is if a high-priority frame is going to be late, it is not worth
sending it at all. The normal-priority queue uses either IEEE 802.3X
PAUSE (variable timed XOFF) flow control or Half D uplex collisions to
shut off incoming frames before the queue overflows.
The switch implements two flow control disciplines along the entire path
that frames travel. The default case is that when output buffers fill up,
frames destined for a particular buffer will be dropped. This should only
occur in a case where the output port is very congested. However, there is
an optional mode in which normal-priority frames are never dropped in si de
the switch. In this mode, input buffers may fill up. If they do, the affected
input ports may use flow control to temporarily halt traffic from
neighboring switches.
* Note: 802.1p packets that are received with a tag priorit y o f 0 on a 50-
series layer 2 (non-routing) module, and that must be routed via
the FORE path on an 80-series supervisor, are queued and
transmitted with a priority of 4. Th is priority change is due to
the conversion from the high-low priority system that 50- se ri es
modules use to the 8-level priority s ystem that 80-series
modules use.
Managing Buffers and Queues
You can manage buffers and queues using either the Web Agent or the CLI.

Web Agent

Procedure To manage buffers and queues using the Web Agent:
1. In the navigation pane, expand the Modules & Ports folder, and then
click Configuration.
The Module Information Web page is disp layed in the content pa ne. See
Figure 24-1.