Document No. 10-300077, Issue 2 12-85
Configuring IP Routing
4. Select Enable from the IRDP State pull-down menu.
5. Select Multicast from the Adv. Address pull-down menu.
6. Modify the default value in the Min. A dvertisement Interval (sec.)
field and enter the minimum time inte rval that passes before the host
contacts the switch.
7. Modify the default value in the Max. A dvertisement Interval (sec.)
field and enter the maximum time in te rval that passes before the host
contacts the switch.
8. Modify the default value in the Advertisement Life Time (sec.) field,
and enter a duration, in seconds , o f the IRDP advertisement.
9. Click APPLY to save your changes, or CANCEL to restore previous
settings.
10. In the navigation pane, expand the Routing > IP > Configuration
folders, and then click Global Configuration.
The IP Global Configuration Web page is di splaye d in t he cont ent p ane .
See Figure 12-35.
11. Select Enable the IP Multicast Forwarding field pull-down menu.
12. Click APPLY to save your changes, or CANCEL to restore previous
settings.
CLI Command To enable IRDP on an interf ace using the CLI, enter the following
command in Enable/Configure/Interface mode:
(config-if:<if name>)# ip irdp