12-38 User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 12
Modifying a DVMRP Interface
You can modify a DVMRP interf ac e us ing either the Web Agent or the CLI.

Web Agent

Procedure To modify a DMVRP interface using the Web Agent:
1. In the navigation pane, expand the Routing > DVMRP folders, and then
click Interfaces.
The DVMRP Interfaces Web page is displayed in the content pane. See
Figure 12-18.
Figure 12-18. DVMRP Interfaces Web Page
* Note: You must first set “multicast protocol” on an interface to
DVMRP before you can configure DVMRP. See “Displaying
Existing IP Interfaces,” earlier in this chapter, and enable a
multicast protocol for this interfac e.
2. See Table12-10 to com plete your DVMRP configuration
3. Click APPLY to save your changes, or CANCEL to restore previous
settings.
Table 12-10. DVMRP Interface Parameters
Parameter Defines the...
Select Select a DVMRP interface that you want to configure.
Interface Displays the Interface that is configured with the
DVMRP multicast protocol.
IP Address Displays the IP address of each interface. You cannot
modify this field.
IP Address Mask Displays the Subnet mask for each interface. You
cannot modify this field.
1 of 2