Document No. 10-300077, Issue 2 17-7
Configuring the IPX RIP Protocol
4. Click Apply to save your changes, or CANCEL to restore previous
settings.
The filter created in this example e nsures that all advertising of netwo rk 10
from the interface labeled Backbone is suppressed.
Example #2: Suppress Advertising of all Networks Except 10
To configure your switch to suppress the advertising of all networks except
network 10 on the IPX interface named Backbone, you must first create t wo
filters.
To create filter 1 from the Web Agent:
1. In the navigation pane, expand the Routing > IPX > RIP folders, and
then click Filters.
The IPX RIP Filter Web page is displayed in the content pane. See
Figure 17-2.
2. Select Create to create a new filter. The Add IPX RIP Filter Web page is
displayed.
3. Configure the following parameter s:
a. Select Backbone from the Interface pull-down menu.
b. Enter 0 in the Precedence field.
c. Enter 10 in the Start Network field.
d. Enter 10 in the End Network field.
e. Select Outbound from the Direction pull-down menu.
f. Select Disable from the Filter/Suppress pull-down menu.
g. Enter 0 in the Ticks and Hops fields.
Filter 1 ensures that the advertis ing of network 10 on the interface
Backbone will not be suppressed. To suppress all other networks, proceed
with the creation of Filter 2.
To create Filter 2 from the Web Agent:
1. Repeat steps 1- 2 in the creating Filter #1 procedure.
2. Configure the following parameter s:
a. Select Backbone from the Interface pull-down menu.
b. Enter 1 in the Precedence field.