12-88 User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 12
CLI Command To configure LDAP settings on a primary and secondary server, use the
following commands:
■To change the LDAP search base,
(configure)# ldap search-base <search-base-DN>
■To change the primary LDAP server’s primary ip address and port,
(configure)# ldap server primary <ip-addr> [<port-num>]
■To change the secondary LDAP server’s primary ip address and
port,
(configure)# ldap server secondary <ip-addr> [<port-
num>]
■To configure policy retrieval to stop on the first error, or ignore
errors,
(configure)# ldap execution-option {stop-on-error | ignore-
errors}
Secondary
Server Port Enter the backup LDAP server port number for the access
control list domain. The port number is used in conjunction
with the secondary server IP address. There are no special
overload values. The default po rt number is 389.
Search Base Enter the search criteria that will be sent to the LDAP server.
The default value is “ou=Devices, ou=AvayaPolicyManager,
o=Avaya”.
Note: No default for the Search Base, this field is empty if
the LDAP server has not been installed:
Execution
Option Open drop-down menu and select stop-on-error or ignore-
errors. This option lets you decide if you want the policy to
continue being sent to the device, if LDAP encounters any
errors. Select stop-on-error if you want execution of the
policy to stop on the first error encountered.Select ignore-
errors if you want execution of the policy to continue even if
errors are encountered. In this case, any commands
containing errors are ignored. The default value is stop-on-
error.
Table 12-34. LDAP Configuration Web Page Parameters
Parameter Allows You To...
2 of 2