Document No. 10-300077, Issue 2 17-3
Configuring the IPX RIP Protocol
CL Command To configure IPX RIP interfaces using the CLI, enter the following
command in Interface mode:
(config-if: <if name>)# ipx rip
Creating and Modifying IPX RIP Filters
You can create and modify IPX RIP filters fro m either the Web Agent or the
CLI.

Web Agent

Procedure To create and modify IPX RIP filters using the Web Agent:
1. In the navigation pane, expand the Routing > IPX > RIP folders, and
then click Filters.
The IPX RIP Filters Web page is displayed in the content pane. See
Figure 17-2. Only the CREATE button is displayed when no filters are
configured.
Triggered Updates Select Disable to disallow RIP updates to be
immediately transmitted to the network in response to
changes in the network topology. The default is
Enable.
Advertise Default
Route Only Select Enable to allow the advertising of the default
network exclusively (subject to a route to the default
network being known to the switch). The default is
Disable.
Mode Select the one of the following modes for the RIP
interface:
• Talk/Listen - Send and receive advertisements.
• Talk Only - Send advertisements.
• Listen Only - Receive advertisements.
The default is Talk/Listen
Table 17-1. IPX RIP Interfaces Web Page Parameters
Parameter Allows you to...
2 of 2