Avaya 580, 882 Resetting the Standby Supervisor

Document No. 10-300077, Issue 2 A-9
Upgrading the Application Software
Figure A-4. System Reset Web Page
3. Select Yes in response to the question, Do you want to reset the switch?
The switch resets and loads the new application software.
CLI Command To reset the switch after do wnloading new application softw a re, use the
following CLI command:
(configure)# reset
Resetting the Standby Supervisor
The previous procedure, “Resetting the Active Supervisor,” forces the
Active Supervisor to Standby mode and the Standby Supervisor to the
Active Supervisor mode. To recover back to the original state, with both
supervisors running new code, reset the current Active supervisor module.
Web Agent
Procedure To reset the Active Supervisor to the Standby Supe rvisor:
1. In the navigation pane, expand the System folder.
2. Select System Reset.
The System Reset Web page is displayed in the content pane (Figure A-
4).
3. Select Yes in response to the question, Do you want to reset the switch?