Bosch Appliances HES7052U manual Self Clean

Cleaning and Maintenance

Setting the Self-Clean Mode

Delaying the Start of the Self-Clean

3.Wipe up excessive soil, spills and grease before self-cleaning the oven. Excess grease will cause flames and smoke inside the oven during self-clean- ing.

Do hand-clean 1 1/2 inches from rack guides to front of oven cavity.

Do not hand-clean the gasket.

Do hand-clean frame area outside the gasket.

Do hand-clean door area outside the gasket.

Figure 18: Cleaning Guidelines

4.Review illustration above. Some areas of the oven must be cleaned by hand before the cycle begins. Use a soapy sponge or plastic scrubber or a deter- gent-filled S.O.S.® pad. Hand-clean the oven door edge, oven front frame and up to 1-1/2 inches inside the frame with detergent and hot water. Do not clean or rub the gasket on the oven. The gasket is designed to hold in heat during the self-clean cycle. Rinse all areas thoroughly then dry.

5.Be sure oven light is turned off and the light bulbs and lens covers are in place. Do not operate oven without light bulb and cover in place.

Important: Do not use Commercial Oven Cleaners on the self-clean oven or any part because they will damage the finish or part.

1.Press COOKING MODE.

2.Turn knob until SELF CLEAN mode appears. Press START.

3.The default cleaning time is 4 hours. To

change cleaning time, turn knob to change	3: 00	SELF CLEAN
number of hours. Otherwise, continue to

step 4. 3

4.Press START. SELF CLEAN flashes. Press

START.

5.REMOVE RACKS appears in the display

as a reminder to remove oven racks.	SELF CLEAN
6. Press START again to begin the self-	4: 00
clean.	REMOVE RACKS

Note: The door locks at the beginning of the

cycle; The door lock symbol will appear in the display at this point. If door does not lock, press OFF and do not self-clean; phone service.

Note: The time of day must be correctly set for this option to work properly. See section “Setting the Clock” in “Setting Up Your Range”.

1.Press COOKING MODE.

2.Turn knob until SELF CLEAN mode appears. Press START.

3.The default cleaning time is 4 hours. To change cleaning time, turn knob to change number of hours. Otherwise, continue to step 4.

4.Press START.

English 34