Brother 9200C owner manual Print OK?, YES 2.NO

The LCD shows CLEANING BLACK. After the cleaning cycle is finished, the LCD shows PRESS START KEY.

9Press Start within one minute. The MFC starts printing the Test Sheet. Only during initial ink cartridge installation, the LCD shows:

PRINT OK?

1.YES 2.NO

10Check the print quality of the test sheet. If it is not good, clean the print head again by pressing 2. The LCD will ask you if the print quality is OK for each color. Press 2 for any color with a problem. You can choose several colors. After cleaning is finished, press Start.

The MFC starts printing Test Sheet No. 2.

11Adjust the Vertical Alignment by following the instructions printed on the Test Print page.

WARNING

If ink gets in your eyes, irrigate them with water immediately and if irritation occurs, consult a doctor.

Caution

■DO NOT remove ink cartridges if you do not need to replace them. If you do so, it may reduce the ink quantity and the MFC will not know the quantity of ink left in the cartridge.

■DO NOT shake the ink cartridges. If you do so, the ink may spill when you take off the sealing tape. If ink stains your body or clothing, wash with soap or detergent immediately.

■If you install an ink cartridge in the wrong color position, you must clean the print head several times after correcting the cartridge installation and before you start printing because the colors were mixed.

■Once you open an ink cartridge, install it in the MFC and use it up within six months of installation. Use unopened ink cartridges by the expiration date written on the cartridge package.

■DO NOT refill the ink cartridges. Attempting to use refilled cartridges may cause damage to the print head and will void your warranty.

Note If the INK EMPTY error message is on the screen display after you have installed the ink cartridges, check and make sure that the ink cartridges are installed correctly.

A S S E M B L Y A N D C O N N E C T I O N S 2 - 11