Brother 9200C owner manual Retrieving Memory Status List, Remote Commands Operation Details

Remote Commands

Follow the commands below to access features remotely. When you call the MFC and enter your Remote Retrieval Access Code (1 5 9 ), the system will signal you with two short beeps to enter a remote command.

	Remote Commands			Operation Details
95		Changing Fax Forwarding
		/Paging setting
		1	OFF	If you hear one long beep, the change is accepted. If you hear three
				short beeps, you cannot change it because the conditions have not
		2	Fax Forwarding
				been met (Example: registering paging number). You can register
		3	Paging	your fax forwarding number by using 4. FAX FWD NO. (see page
				8-5). Once you have registered the number, the MFC will change
		4	FAX FWD No.
				automatically to FAXFWD:ON mode. Then retrieve a Memory
				Status List by entering 961 (see page 8-4) to make sure that the
				Fax Forwarding number you registered is correct in the List.
		6	Fax Storage ON	You can turn FAX STORAGE to ON or OFF.
		7	Fax Storage OFF
96		Retrieve a fax
		1	Memory Status List	Enter the number of a remote fax machine to receive the Memory
				Status List or stored fax message(s). (See page 8-5.)
		2	Retrieve all faxes
		3	Erase fax from the memory	If you hear one long beep, you can erase fax message(s) from the
				memory.
97		Check the Receiving Status
		1	FAX	You can check whether your MFC has received any faxes. If yes,
				you will hear one long beep. If no, you will hear three short beeps.
98		Change Receive Mode
		1	EXT. TEL/TAD	If you hear one long beep, you can change the Receive Mode.
				If you hear three short beeps, you cannot change it.
		2	FAX
90		Exit		After a long beep, you can exit remote retrieval.

Retrieving Memory Status List

You can retrieve the Memory Status List from a remote fax machine to see if you have any fax messages.

1Dial your fax number.

2When you hear the beep, immediately enter your Remote Retrieval Access Code (1 5 9 ).

3When you hear two short beeps, use the dial pad to press 9 6 1.

4Using the dial pad, enter the number of the remote fax machine where you want the Memory Status List forwarded (up to 20 digits), and then press # #.

Note You cannot use and # as dial numbers. However, if you want to store a pause, press #.

5After you hear your MFC beep, hang up and wait.

Your MFC will call the remote fax machine. The remote fax machine will print the Memory Status List.

R E M O T E F A X O P T I O N S ( N O T A V A I L A B L E F O R C O L O R F A X ) 8 - 4