Brother 9200C owner manual Access Codes and Credit Card Numbers, For example

■To stop the broadcasting in progress, press Stop. The LCD asks if you want to cancel all locations or only the location that is being sent.

■Enter the long dialing sequence numbers as you normally would, but keep in mind that each key counts as one location, so the number of locations you can call becomes limited.

■If the line is busy or for some other reasons a connection could not be made while broadcasting, the MFC will redial the number automatically.

■If the memory is full, press Stop to abort the job or press Start to send the portion that is in the memory (if more than one page has been scanned).

1Place the original face up in the ADF, or face down on the scanner glass.

2Enter a number using One Touch, Speed Dial, a Group number or Search. Example: Group number

3Press Set. You will be prompted to press the next number.

4Enter the next number. Example: Speed Dial

5Press Set.

6Enter the fax number.

Example: Manual dialing, using the dial pad.

7Press Start.

Your MFC will read the original into memory and then start sending faxes to the numbers you entered.

Access Codes and Credit Card Numbers

Sometimes you may want to choose from among several long distance carriers when you make a call. Rates may vary depending upon the time and destination. To take advantage of low rates, you can store access codes or long-distance carriers as One Touch or Speed Dial numbers. You can store these long dialing sequences by dividing them and setting them up on separate keys in any combination. You can even include manual dialing using the dial pad. The combined number will be dialed in the order you entered it, as soon as you press Start. (See Storing One Touch Dial Numbers, page 7-1.)

For example:

You can store “555” on One Touch key 3 and “7000” on One Touch key 2. If you press One Touch 3, 2, and Start, you can dial “555-7000”. To temporarily change a number, you can substitute part of the number with manual dialing using the dial pad. For example, to change the number to 555-7001 you could press One Touch 3 and press 7, 0, 0, 1 using the dial pad.

Note If you must wait for another dial tone at any point in the dialing sequence, store a pause at that point in the number by pressing Redial/Pause. Each key press adds a 3.5 second delay.

7 - 5 A U T O D I A L N U M B E R S A N D D I A L I N G O P T I O N S