Brother BES-962BC instruction manual 249

				Chapter 11	Error code list
Code	Error			Measures
E-C3	Embroidering data buffer empty	Is the IF cable disconnected? If it is connected normally, the cable or the
		main board is faulty.
E-C4	Presser foot down error	Press the STOP or turn on the F/B switch on the head to either side. If the
		same error occurs again, adjust the presser foot switch.
E-C5	Measured voltage value could not be received form
	the lower shaft motor CPU.
		This is not usually displayed.
E-C6	Voltage value could not be transferred to the lower
	shaft motor CPU.
		The machine may be being tested in the BC test mode. Exit the test mode
E-C7	Lower shaft error	or turn the power off and on once. If the same error occurs again, the main
		PCB is faulty.
E-C8	Hook motor origin point error	Check the operation of the main shaft brake and the stop position of the
		main shaft (100 degrees).
		The	is pressed while no sewing data has been transferred to the em-
E-C9	Embroidering start error	broidery machine. Clear this error by the STOP . To start sewing, transfer
		necessary data from the machine controller and press the			.
E-CA	No sewing permission is given from PC.	This is not usually displayed.
		Press the STOP or turn on the F/B switch on the head to either side to cancel
E-CB	Spindle rotation speed error	the error and press the		. If the same error occurs again, there is a
		possibility that the spindle is overloaded.
E-CC	Shuttle thread entanglement automatic reset	This is not usually displayed.
E-CD	Speed command can not be received.	Turn the power off and on once. If the same error occurs again, the main
		PCB is faulty.
E-CE	Cylinder bed position error	Secure the bed. If the bed is secured, the bed sensor position may be
		faulty. Readjust it.
E-CF	Rated voltage value could not be received from the	Turn the power off and on once. If the same error occurs again, the main
	lower shaft motor CPU.	PCB is faulty.
E-D0	Power PC board error	Turn the power off and on once. If the same error occurs again, the power
		PCB is faulty.
E-D1	Cooling fan motor stop B Tum the power off.	Turn off the power and check the fan harness. Turn on the power again. If
		the same error occurs again, the fan or the power PCB is faulty.
E-D2	Power voltage upper limit error	(1) The voltage setting is improper. -> Set it again.
		(2) Press the STOP or turn on the F/B switch on the head to either side. If
E-D3	Power voltage lower limit error	the same error occurs again, the power PCB or the power supply is
		faulty.
E-E1	X-axis pulse motor overcurrent stop
		Turn the power off and on once.
E-E2	Y-axis pulse motor overcurrent stop
E-E3	Cooling fan motor stop A Press R.	Turn off the power and check the fan harness. Turn on the power again. If
		the same error occurs again, the fan or the power PCB is faulty.
E-E4	Lower shaft communication error	Turn the power off and on once. If the same error occurs again, the main
		PCB is faulty.
E-E5	Over-run error during interfacing to main PCB CPU
E-E6	Framing error during interfacing to main PCB CPU
		This is not usually displayed.
E-E7	Parity error during interfacing to main PCB CPU
E-E8	Receiving time up error during interfacing to main
	PCB CPU

BES-962BC • BES-1262BC 249