Chapter 10 Adjustment
1.Turn the pulley B q until the scale of pulley B q indicates 180˚ (where the pulley B indication mark "
" and the stop mark "
" are aligned) and the needle bar is set at the lowest position.
2.Insert the positioning bar w into the hole of the pulley B q and fix the drive shaft.
Note) Turn the pulley B securely in the clockwise direction.
3.Insert the bottom dead center gauge e into the rotary hook r.
4.Loosen the screw y of the needle bar clamp t and Socket head bolt for top dead center stopper o, then move the needle bar up and down until the needle tip touches the gauge e lightly.
Note) • The needle point should touch the gauge at a place other than the cutting section.
•The bottom dead center gauge should be set in or removed from the rotary hook with its cutting section facing upward.
5.Tighten the screw y of the needle bar clamp t securely.
6.After adjustment is finished, remove the positioning bar w.
7.Set the needle bar at the highest position (where the pulley B indication mark " 
" and the cover indication mark " 
" are aligned). Lightly press the top dead center stopper u toward the cushion rubber i, and tighten Socket head bolt for top dead center stopper o while pressing down the needle bar clamp so that it faces the front. (Tightening torque: 0.78 N.m)
Note) • Make sure that the top dead center stopper u does not hit the needle bar guide rail !0at this time.
235 |
