Brother BES-962BC instruction manual For embroidering with flat hoop/sash frame upper position

Chapter 2 Preparation of Embroidery Machine

For embroidering with flat hoop/sash frame (upper position)

t

u

w q

e Pin

i

r

i

y

1.Attach four hexagon socket head cap screws to each of F table parts R q, M (2 pcs) w, and L e from the back.

2.Mount the F table parts from L e in order. Insert the bent part (upper) of F table guide UN r into the guide. Insert the F table rear pin into the hole of leg cover t.

3.Adjust F table supports F y in height so as to make the F table lower than the bed top by 1 mm.

4.Tighten all hexagon socket head cap screws firmly.

5.Attach five thumb bolts to the lower front steel pipe of the leg section. Fasten the F table and the leg section using F table stays A (3 pcs) u and B (2 pcs) i.

Procedure for embroidering with flat hoop/sash frame and every other head

Only the odd-numbered heads are operated for embroidering with flat hoop/sash frame. Embroidering is possible within an area up to 500 mm in the X-axis direction.

1.Set the needle bar case in the needle bar No. 1 position. Remove the presser feet.

2.Select a flat hoop (sash frame) for every other head operation.

BES-962BC • BES-1262BC 35