Brother BES-962BC instruction manual 247

Chapter 11 Error code list

Code	Error	Measures
		This is displayed when every other head control is selected or when the
		bed is retreated (including when the power is turned on). Remove the
	When the power is turned on, bed can not be re-	presser foot of the retreating head and press the return key or turn the F/B
E-1E		switch of the head to either side. If every other head control is not selected
	tracted.
		or the bed is not retreated, the bed sensor position may be faulty. Readjust
		it. Press the STOP key. If the same error occurs again, adjust it with the
		presser foot switch.
E-1F	Presser foot down error while searching for home	Press the STOP or turn on the F/B switch on the head to either side. If the
	position just after the power is turned on.	same error occurs again, adjust the presser foot switch.
E-21	Hoop overhang(+X)
E-22	Hoop overhang(+Y)
E-23	Hoop overhang(+X, +Y)
E-24	Hoop overhang(-X)
E-25	Hoop overhang(+X, -X)
E-26	Hoop overhang(-X, +Y)
E-27	Hoop overhang(+X, -X, +Y)
E-28	Hoop overhang(-Y)
E-29	Hoop overhang(+X, -Y)
E-2A	Hoop overhang(+Y, -Y)
E-2B	Hoop overhang(+X, +Y, -Y)
		Pattern or the needle position is out of the embroidering area. Reset the
E-2C	Hoop overhang(-X, -Y)
		embroidering area on PC or move the hoop to the sewable position.
E-2D	Hoop overhang(+X, -X, -Y)
E-2E	Hoop overhang(-X, +Y, -Y)
E-2F	Hoop overhang(+X, -X, +Y, -Y)
E-31	Needle overhang(+X)
E-32	Needle overhang(+Y)
E-33	Needle overhang(+X, +Y)
E-34	Needle overhang(-X)
E-36	Needle overhang(-X, +Y)
E-38	Needle overhang(-Y)
E-39	Needle overhang(+X, -Y)
E-3C	Needle overhang(-X, -Y)
E-40	The status of presser foot is issued as an alarm when	When using the every other head mode, remove the presser feet according
	every second machine is used.	to the warning message.

E-41

Invalid start-up error

Turn the power off and on once.

E-42

XY movement error

Press the or turn on the F/B switch on the head to either side.

STOP

BES-962BC • BES-1262BC 247