Brother BES-962BC instruction manual 246

Chapter 11 Error code list

Code	Error		Measures
E-00	No error occurs.
		This is not usually displayed.
E-01	Either motor of main shaft, X- or Y-axis, or lower
	shaft has locked.
E-02	Overtravel occurs during home position detecting	Turn the power off and on once. If the same error occurs again, the home
	movement.	position sensor is faulty.
E-03	The stop switch is pressed during home position de-	Press the	STOP or turn on the F/B switch on the head to either side to restart
	tecting movement.	the home position detecting movement again.
E-04	Zero detecting movement out of range	This is not usually displayed.
E-05	Needle stop position error	Adjust the pulley stop position (100 degrees) above the needle and press
		the STOP or turn on the F/B switch on the head to either side.
E-06	Needle bar case position error	This is not usually displayed.
E-07	Needle bar case lock	Press the	STOP or turn on the F/B switch on the head to either side. If the
		same error occurs again, the color change mechanism is faulty.
E-08	Stop switch or emergency switch was pressed while	This is not usually displayed.
	the needle bar case is traveling.
E-09	X-axis home position detection error	Turn the power off and on once. If the same error occurs again, the X-axis
		mechanism is faulty.
E-0A	Thread breaking error	After passing through the thread, press the STOP or turn on the F/B switch on
		the head to either side.
E-0B	Stop or emergency stop during sewing
		This is not usually displayed.
E-0C	Insufficient bobbin thread
E-0D	The machine does not return to the home position.	Turn the power off and on once.
E-0E	Mending finish
		This is not usually displayed.
E-0F	Undefined error
E-14	Y-axis home position error	Turn the power off and on once. If the same error occurs again, the Y-axis
		mechanism is faulty.
E-15	Stop error during SSP processing (when pressing	Hoop movement restarts if you press		.
	the stop key while the hoop is moving)
E-16	The destination needle bar number given from PC is
	out of the movable area.
		This is not usually displayed.
E-17	The speed Vol. number given from PC is out of the
	appropriate range.
E-18	X-axis stepping motor connector error	Turn the power off and on once after checking to see that the connector of
		the X-axis stepping motor is properly connected.
E-1A	Destination coordinates error
		This is not usually displayed.
E-1B	The machine has reached the mending stop position.
E-1C	The machine stops during mask tracing.	Tracing is cancelled if the STOP key is pressed when the machine is stopped
		during mask tracing. Press the		key to continue tracing.
	The machine stops while the needle is moving be-	This is displayed when the stop switch is pressed while the hoop is moving.
E-1D		Press the	to move the hoop again. (It is necessary to press the
	tween patterns during repeat sewing.
		again to start sewing.)

Errors E-1C and E-1D are not displayed due to mechanical problems.

246 BES-962BC • BES-1262BC