Canon WUX10 manual Aspect

Projector WUX10 MarkII User Commands

ASPECT

Screen settings

Format

ASPECT=<Screen setting parameters:ID>

GET□ASPECT / ?△ASPECT

<Screen setting parameters:ID>

AUTO	Auto
4:3	4:3
16:9	16:9
FULL	Full screen
ZOOM	Zoom
TRUE	Real

Environment

	Power					Input
OFF	ON	PM	Parameter	D-RGB	A-RGB1	A-RGB2	COMP	VIDEO	HDMI	None
X	O	X	AUTO	○	○	○	○	×	○	*4
			4:3	○	○	○	○	○	○	*4
			16:9	○	○	○	○	○	○	*4
			FULL	*5	*5	*5	×	×	×	*4
			ZOOM	×	×	×	*1	*2	*1	*4
			TRUE	○	○	○	*3	×	*3	*4

*1 Valid when screen aspect (16:9 or 16:9 DIS) and SD signals *2 Settable when screen aspect (16:9 or 16:9 DIS)

*3 Progressive allowable (however, 1080p is non-allowable)

*4 Allowable/Non-Allowable differs according to selected input signal *5 Settable when screen aspect (16:10)

Response

"i:OK" is returned if the parameter was set properly.

For 'GET ASPECT' or '?ASPECT', current screen display mode is returned as

'g:ASPECT=<Screen setting parameters:ID>'

For details on other responses, refer to the "Error List".

Description

(1)This sets the screen sizes.

(2)This command functions in the same way as when "Display settings" - "Aspect" are selected on the menu.

(3)If the command cannot be supported, 'INVALID_SOURCE' is returned as an error response.

(4)If the necessary signals are not input, 'NO_SIGNAL' is returned.

(5)The final screen settings are retained even when the power is turned off. However, the screen settings may be different if the input terminal or input signal is changed.

(6)The GET command can be used to retrieve the current screen display mode. ("GET ASPECT")

Revision History / Date

Changes

Revised by

Approved by

- 16 -