Canon Fcontdrv, Projector WUX10 MarkII User Commands, Format, Environment, Response, Example

Projector WUX10 MarkII User Commands

FCONTDRV

Focus lens continuous drive control

Format

FCONTDRV=<Focus lens continuous control parameter:ID>

<Focus lens continuous control parameter:ID>

STOP	This stops the focusing.
FAR	This initiates focusing toward the far end.
NEAR	This initiates focusing toward the near end.

Environment

	Power					Input
OFF	ON	PM	D-RGB	A-RGB1	A-RGB2	COMP	VIDEO	HDMI	None
X	O	X	-

Response

"i:OK" is returned when the drive was completed successfully. For details on other responses, refer to the "Error List".

Description

(1)This command is used to drive the focus lens.

(2)This command functions in the same way as when first the "FOCUS" button on the remote control or main unit panel is pressed and then the "↑" or "↓" button is pressed.

(3)Focus drive is started by specifying "NEAR" or "FAR".

To stop the drive, add the "STOP" parameter and send this command.

If no instruction was given to stop the drive, the drive stops at the drive direction end.

(4)The following commands are acknowledged during focus drive, but focus drive will also stop at the same time.

a.POWER

b.FCONTDRV=STOP

(5)The following commands are acknowledged during focus drive, and a response is returned while the drive continues.

a.	GET MODE	e. GET PRODCODE	i.	LOCAL
b.	GET POWER	f. GET ROMVER	j.	RC
c.	GET ERR	g. GET COMVER	k.	MAIN
d.	GET LAMPCOUNTER	h. REMOTE	l.	[NULL]

(6)For other commands not included in (4) nor (5), "i:BUSY (FOCUS)" is returned, and focus drive continues.

(7)There are no GET commands available for this command.

Example

Control	Control over the focusing to the near end is started.
> FCONTDRV=NEAR

<i:OK

*Commands are indicated by ">", and responses are indicated by "<".

Revision History / Date

Changes

Revised by

Approved by

- 31 -