Canon Power, Projector WUX10 MarkII User Commands, Format, Environment, Response, Description

Projector WUX10 MarkII User Commands

POWER

This controls the power supply

Format

POWER□<Parameter:ID>

GET□POWER / ?△POWER

<Parameter:ID>
ON	Power ON
OFF	Power OFF

Environment

	Power					Input
OFF	ON	PM	D-RGB	A-RGB1	A-RGB2	COMP	VIDEO	HDMI	None
-			-

Response

"i:OK" is returned if the parameter was set properly.

For 'GET POWER' or '?POWER', current power supply status is returned as shown in the table below.

Response	Status
'g:POWER=OFF'	OFF
'g:POWER=OFF2ON'	OFF -> ON in transition
'g:POWER=ON'	ON
g:POWER=ON2PMM'	ON -> Standby in transition
'g:POWER=PMM'	Standby
'g:POWER=PMM2ON'	Standby -> ON in transition
'g:POWER=ON2OFF'	ON -> OFF in transition

For details on other responses, refer to the "Error List".

Description

(1)This performs ON/OFF control of the power supply.

(2)This command is identical to pressing the POWER button on the remote control.

(3)Processing of other commands (including ZOOM/FOCUS) will be interrupted at "POWER OFF" when the power is ON.

(4)'i:BUSY' will be returned at "POWER ON" during power OFF transition. For other cases, 'I:OK' will always be returned.

(5)After sending this command, use GET POWER to obtain the power supply state at regular intervals, and check that it is in the controlled state (off or on).

(6)The current power supply status can be referenced using the applicable GET command. ("GET POWER")

(7)Even when it is powered up by using this command, "Prepare for lamp replacement", "Lamp replacement warning", "Clean filter warning" will display for 10 seconds as usual.

Example

Control

>POWER ON < i:OK

Reference

>GET POWER or ?POWER < g:POWER=OFF

*Commands are indicated by ">", and responses are indicated by "<".

Revision History / Date

Changes

Revised by

Approved by

- 56 -