Canon SX60, X600 specifications Wide, Zstepdrv=Tele, Range Zstepdrv

User Command Specifications ９．Details of command ZSTEPDRV

Commands	ZSTEPDRV			Mode	Control	Setting	Reference
Function	Zoom lens step drive control
Format		ZSTEPDRV=<Zoom lens step control parameter：ＩＤ>
Parameter	Zoom lens step control parameters
		Parameter	Meaning
		WIDE	This zooms to the wide-angle end.
		TELE	This zooms to the telephoto end.				ＩＤ
	The parameters which can be set at any given point in time can be obtained using the
	RANGE command.
	For details, refer to the RANGE command.
Response	"i:OK" is returned when zooming was completed successfully after step drive.
	For all other responses, refer to "Error List."
Description	This command is used to initiate the step drive of the zoom lens.

(1)It can be executed when the projector is in both the remote mode and power-onstatus at the same time.

However, a "busy" response is given while the zoom or focus lens is being driven.

（Refer to the ZCONTDRV command and FCONTDRV command. ）

(2)This command functions in the same way as when first the "ZOOM" button on the remote control or main unit panel is pressed and then the "←" or "→" button is pressed.

(3)The amount by which the lens is zoomed is constant, and it is fixed in the system.

(4)If a zooming error occurs, step drive cannot be controlled.

Example Control

> ZSTEPDRV=TELE

1-step control is exercised over the zoom toward the TELE end.

< I:OK

Range acquisition

> RANGE ZSTEPDRV

< r:ZSTEPDRV=I, WIDE, TELE

"WIDE" or "TELE" can be set as the step control of the zoom.

Commands

SX50

SX6

SX60

X600

supported

０１．００**

０１．０１**

０１．０１**

０１．０１**

×

○

○

○

When a command is not supported, "e:0002 INVALID_COMMAND" is returned.

Supported Command States

Model

Power supply

Input

Mode

Remarks

OFF

ON

PM

D-RGB

A-RGB1

A-RGB2

Comp

Video

S-Video

D-Video

SCART

None

Remote

Local

SX50

－

－

－

－

－

－

－

－

－

－

－

－

－

－

SX6

×

○

×

○

○

○

○

○

○

○

○

○

○

×

SX60

X600

*If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response. *When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.

PAGE 65