User Command Specifications 9. Details of command KEYLOCK
1
KEYLOCK
KEYLOCK
KEYLOCK=<Key lock setting parameter
s
：ＩＤ>
Key lock setting parameters
-1
A "busy" response is given while the zoom or focus lens is being driven.
-2
Menu
[System settings] - [Key lock]
[System settings] - [Key lock]
-3
-4
Setting
> KEYLOCK=RC This locks the remote control keys.
< i:OK
Reference
> GET KEYLOCK or ?KEYLOCK This retrieves the key lock state.
< g:KEYLOCK=OFF
Acquisition of parameters which can be set
> RANGE KEYLOCK
< r:KEYLOCK=I,OFF,MAIN,RC
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command State
s
OFF ON PM
×○×
×○×
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
Example
Keylock setting
"i:OK" is returned if the parameter was set properly.
Description
Function
Parameter
This command will not affect the emulation function (remote control or main unit commands)
even if the main unit or remote control keys are locked!
The current key lock setting can be acquired using the applicable GET command.
It can be executed when the projector is in both the remote mode and power-on status at the
same time.
No locking (OFF)
ID
Response
OFF
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
For details, refer to the RANGE command.
This command is the same as the menu functions in the table below.
Commands
Paramete
r
Meaning
RC Remote control key loc
k
MAIN Main key lock
For all other responses, refer to "Error List."
Mode
01.00** 01.01** 01.01** 01.01**
SX50
○○○
Model Power Input Mode
Remote Local Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-VideoSCART None
SX50 ○○○○○○––○○×
SX6 ○○○○○○○○○○×
SX60
Format
X600
Setting Reference
Command
s
supported
This command is used to lock the keys so as to restrict the operations performed using the remote
control or main unit.
(Refer to the ZCONTDRV command and FCONTDRV command.)
For details, refer to the GET command.
"OFF," "MAIN" or "RC" can be selected as the key
lock setting.
Model
○
X600
Control
SX50
SX6
SX60
SX6 SX60 X600
PAGE 60