Canon SX60, X600 specifications Sel, Format SEL=Input signal selection parameter ID

User Command Specifications 9. Details of command SEL

1

Commands	SEL			Mode	Control	Setting	Reference
Function	Input signal selection
Format		SEL=<Input signal selection parameter: ID>
Parameter Input signal selection parameter
		Parameter	Meaning
		AUTO	Auto

ID

The parameters which can be set at any given point in time can be obtained using the RANGE command.

For details, refer to the RANGE command.

Response "i:OK" is returned if the parameter was set properly.

For all other responses, refer to "Error List."

Description This selects the input signal.

-1 It can be executed when the projector is in both the remote mode and power-onstatus at the same time.

A "busy" response is given while the zoom or focus lens is being driven. (Refer to the ZCONTDRV command and FCONTDRV command.)

Furthermore, it may not be possible to execute the command with some input signals. -2 This command takes effect only with the "AUTO" parameter setting.

-3 This command is the same as the menu functions in the table below.

Model Menu

SX50 [Display settings] - [Input signal selection] - [Auto]

SX6

SX60 [Display settings] - [Input signal selection] - [Auto]

X600

-4 The current input signal can be acquired using the applicable GET command.

For details, refer to the GET command.

Parameter

Remarks

PAL

Includes PAL-M and PAL-N

SECAM

NTSC

Includes NTSC4.43

1080i

Includes 540p (1080i non-interlaced signal)

1035i

720p

575p

480p

575i

Includes 288p (PAL non-interlaced signal)

480i

Includes 240p (NTSC non-interlaced signal)

UNKNOWN

No-color, 1080p, and other signals

List of signals which can be detected

Example Setting

> SEL=AUTO

This sets the input signal selection to “AUTO”.

< i:OK

Reference

> GET SEL or ?SEL

This retrieves the input signal.

< g:SEL=575p

Acquisition of parameters which can be set

> RANGE SEL

< r:SEL=I, AUTO

Only "AUTO" can be set for the input signal selection.

* Commands are indicated by ">", and responses are indicated by "<".

Commands

SX50

SX6

SX60

X600

supported

01.00**

01.01**

01.01**

01.01**

○

○

○

○

Supported Command States

Model

Power

Input

Mode

Remarks

OFF

ON

PM

D-RGB

A-RGB1

A-RGB2

Comp

Video

S-Video

D-Video

SCART

None

Remote

Local

SX50

×

○

×

×

×

×

○

○

○

–

–

×

○

×

SX6

×

○

×

×

×

×

○

○

○

×

×

×

○

×

SX60

X600

*If the command cannot be supported, 'INVALID_MODE,' 'NOT_POWER_SUPPLIED' or 'INVALID_SOURCE' is returned as an error response.

*If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.

*"i:BUSY" may be returned if the power status is being switched.

PAGE 25