Canon SX60, X600 specifications Format PMM=Power management setting parameters ：ＩＤ, Pmm=Standby

User Command Specifications 9. Details of command PMM

1

Commands	PMM			Mode	Control	Setting	Reference
Function	Power management
Format		PMM=<Power management setting parameters：ＩＤ>
Parameter Power management setting parameters
		Parameter	Meaning
		OFF	OFF
		STANDBY	Standby mode
		EXIT	Exit mode				ID

The parameters which can be set at any given point in time can be obtained using the

RANGE command.

For details, refer to the RANGE command.

Response "i:OK" is returned if the parameter was set properly.

For all other responses, refer to "Error List."

Description This sets Power management mode.

-1 It can be executed when the projector is in both the remote mode and power-onstatus at the same time.

A "busy" response is given while the zoom or focus lens is being driven. (Refer to the ZCONTDRV command and FCONTDRV command.)

-2 This command is the same as the menu functions in the table below.

Model Menu

SX50 [System settings] - [Power management modes]

SX6

SX60 [System settings] - [Power management modes]

X600

-2 With the SX6, SX60 or X600, power management cannot be set to OFF if ON has been selected as the direct power-on setting (DPON=ON). ("e:1005 DIRECT_POWER_ON" is

-3 The projector behaves as follows with the power management setting and in the remote mode.

Model	Projector behavior
SX50	In the remote mode, the power management setting is ignored.
	This setting takes effect only when the local mode is established.
SX6	Even in the remote mode, the projector operates as per the power management
SX60	setting.
X600	However, when it starts operating, it is automatically transferred to the "local
	mode."

-4 The current power management mode can be acquired using the applicable GET command. For details, refer to the GET command.

Example Setting

> PMM=STANDBY

This sets the power management to "standby."

< i:OK

Reference

> GET PMM or ?PMM

This retrieves the Power management mode.

< g:PMM=EXIT

Acquisition of parameters which can be set

> RANGE PMM

< r:PMM=I, OFF, STANDBY, EXIT

"OFF," "STANDBY" or "EXIT" can be set for the power

management.

* Commands are indicated by ">", and responses are indicated by "<".

Commands

SX50

SX6

SX60

X600

supported

01.00**

01.01**

01.01**

01.01**

○

○

○

○

Supported Command States

Model

Power

Input

Mode

Remarks

OFF

ON

PM

D-RGB

A-RGB1

A-RGB2

Comp

Video

S-Video

D-Video

SCART

None

Remote

Local

SX50

×

○

×

○

○

○

○

○

○

–

–

○

○

×

SX6

×

○

×

○

○

○

○

○

○

○

○

○

○

×

SX60

X600

*If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.

*"i:BUSY" may be returned if the power status is being switched.

PAGE 53