Canon SX60, X600 specifications Format RCCH=Remote control setting parameters ：ＩＤ, Range Rcch

User Command Specifications 9. Details of command RCCH

1

Commands	RCCH				Mode	Control	Setting	Reference
Function	Remote control setting
Format		RCCH=<Remote control setting parameters：ＩＤ>
Parameter Remote control setting parameters
		Parameter		Meaning
		1		Remote control channel 1
		2		Remote control channel ２				ID
	The parameters which can be set at any given point in time can be obtained using the
	RANGE command.
	For details, refer to the RANGE command.
Response "i:OK" is returned if the parameter was set properly.
	For all other responses, refer to "Error List."
Description This command is used to set the channel of the remote control used at the projector end to 1 or 2.
	-1 It can be executed when the projector is in both the remote mode and power-onstatus at the
		same time.
		A "busy" response is given while the zoom or focus lens is being driven.
		(Refer to the ZCONTDRV command and FCONTDRV command.)
	-2This command is identical to the Remote control function in the System settings menu.
			Model	Menu
			SX50	[System settings] - [Remote control]
			SX6	[System settings] - [Other settings] - [Remote control]
			SX60
			X600

-3The current remote control setting can be acquired using the applicable GET command. For details, refer to the GET command.

Example Setting

> RCCH=1

This sets the remote control channel to ch1.

< i:OK

Reference

> GET RCCH or ?RCCH

This retrieves the remote control setting state.

< g:RCCH=2

Acquisition of parameters which can be set

> RANGE RCCH

< r:RCCH=I, 1, 2

"1" or "2" can be set as the remote control channel.

* Commands are indicated by ">", and responses are indicated by "<".

Commands

SX50

SX6

SX60

X600

supported

01.00**

01.01**

01.01**

01.01**

○

○

○

○

Supported Command States

Model

Power

Input

Mode

Remarks

OFF

ON

PM

D-RGB

A-RGB1

A-RGB2

Comp

Video

S-Video

D-Video

SCART

None

Remote

Local

SX50

×

○

×

○

○

○

○

○

○

–

–

○

○

×

SX6

×

○

×

○

○

○

○

○

○

○

○

○

○

×

SX60

X600

*If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.

*"i:BUSY" may be returned if the power status is being switched.

PAGE 61