Canon X600, SX60 specifications GET Romver, GET Comver, Zcontdrv=Tele

User Command Specifications ９．Details of command ZCONTDRV

Commands	ZCONTDRV			Mode	Control	Setting	Reference
Function Zoom lens continuous drive control
Format		ZCONTDRV=<Zoom lens continuous control parameter：ＩＤ>
Parameter	Zoom lens continuous control parameters
		Parameter	Meaning
		STOP	This stops the zooming.
		WIDE	This zooms to the wide-angle end.
		TELE	This zooms to the telephoto end.				ＩＤ

The parameters which can be set at any given point in time can be obtained using the

RANGE command.

For details, refer to the RANGE command.

Response "i:OK" is returned when the drive was completed successfully.

For all other responses, refer to "Error List."

Description This command is used to drive the zoom lens continuously.

(1)It can be executed when the projector is in both the remote mode and power-onstatus at the same time.

However, only the "STOP" parameter takes effect while the zoom lens is being driven, and a "busy" response is given while the focus lens is being driven.

（Refer to the FCONTDRV command. ）

(2)This command functions in the same way as when first the "ZOOM" button on the remote control or main unit panel is pressed and then the "↑" or "↓" button is pressed.

(3)Zoom drive is started by specifying "TELE" or "WIDE." To stop the drive, add the "STOP" parameter and send this command.

If no instruction was given to stop the drive, the drive stops at the drive direction end.

(4)The following commands are acknowledged during zoom drive, but zoom drive will also stop at the same time.

In the case of any other commands, "i:BUSY (ZOOM)" is returned unconditionally, and zoom drive continues.

a.REMOTE

b.LOCAL

c.POWER

d.ZCONTDRV=STOP

(5)The following commands are acknowledged during zoom drive, and a response is returned while the drive continues.

a. GET MODE	e.	GET PRODCODE
b. GET POWER	f.	GET ROMVER
c. GET ERR	g.	GET COMVER
d. GET LAMPCOUNTER

(6)Zoom drive stops when the "POWER" button on the remote control or main unit panel is pressed during zoom drive.

Example Control
	> ZCONTDRV=TELE				Control over the zooming to the telephoto end is started.
	< I:OK
	Range acquisition
	> RANGE ZCONTDRV
	< r:ZCONTDRV = I, STOP, WIDE, TELE				"STOP," "WIDE" or "TELE" can be set for zoom lens
					continuous drive.
Commands	SX50	SX6	SX60	X600
supported	０１．００**	０１．０１**	０１．０１**	０１．０１**
	×	○	○	○
	When a command is not supported, "e:0002 INVALID_COMMAND" is returned.

▼

Supported Command States

Model

Power supply

Input

Mode

Remarks

OFF

ON

PM

D-RGB

A-RGB1

A-RGB2

Comp

Video

S-Video

D-Video

SCART

None

Remote

Local

SX50

－

－

－

－

－

－

－

－

－

－

－

－

－

－

SX6

×

○

×

○

○

○

○

○

○

○

○

○

○

×

SX60

X600

*If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response. *When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.

PAGE 66