Cisco Systems 1550, AIRCAP1552HAK9 manual Radio Cover Screw Tightening Sequence

Chapter 4 Installing or Replacing the Backup Battery

Connecting the Backup Battery Cable and Closing the Radio Cover

Connecting the Backup Battery Cable and Closing the Radio Cover

To connect the backup battery cable and close the access point radio cover, follow these steps:

Step 1 Carefully position the access point radio cover over the access point as shown in Figure 4-2.

Step 2 Hold the radio cover upright while placing the edge of the radio cover on the top edge of the access point. Step 3 Carefully push the backup battery cable connector into the internal battery connector (see Figure 4-2). Step 4 Close the radio cover, while being careful not to pinch the backup battery cable.

Step 5 Use a Phillips screwdriver to partially tighten each cover screw in the tightening sequence, starting with 1, as shown in Figure 4-4. Tighten each screw to 11 to 12 in. lbs (1.24 to 1.36 Nm).

Step 6 Repeat Step 5 using the same tightening sequence to fully tighten each screw to 22 to 24 in. lbs (2.49 to 2.71 Nm).

Figure 4-4 Radio Cover Screw Tightening Sequence

1 9 3

8

6

5

7

		255268
4	10	2

What to Do Next

After you have completed the backup battery procedures, your access point is ready to be deployed. Carefully read and follow the safety and installation guidelines contained in the “Installation Guidelines” section on page 2-8and the installation and mounting instructions contained in the “Mounting the Access Point” section on page 2-14.

Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide

4-6 OL-24247-01