Cisco Systems AIRCAP1552HAK9, 1550 manual AIR-CAP1552EU-x-K9

Chapter 2 Installing the Access Point

Powering the Access Point

Warning This unit might have more than one power supply connection. All connections must be removed to de-energize the unit. Statement 1028

Note If your access point contains a backup battery pack, you must press the reset button for 10 seconds or more (see the “Disabling Backup Battery Power” section on page 3-10).

Step 2 Ensure a 6 AWG ground wire is connected to the access point (see the “Grounding the Access Point” section on page 2-41).

Step 3 Use an adjustable wrench, a 22-mm socket, or the Sealcon S-2200-WR wrench to remove the Ethernet connector plug from the access point (see Figure 2-34for the location).

Figure 2-34 Location of Ethernet Liquid-Tight Adapters (Only Models AIR-CAP1552E-x-K9 and

AIR-CAP1552EU-x-K9)
4	5	6
1	2	255260

1

PoE-in port

2

PoE-out port

Note For information on data cable entry, refer to Figure 1-1 on page 1-6

Step 4 Loosen the round end of the liquid-tight adapter by turning counterclockwise, but do not remove (see Figure 2-35).

	Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
OL-24247-01		2-47