Cisco Systems AIRCAP1552HAK9, 1550 Installing 1552E, 1552EU, or 1552I in the Mounting Bracket

Chapter 2 Installing the Access Point

Mounting the Access Point

Step 8 Install four M8 x16 bolts (with flat and lock washers) into the bolt holes.

Figure 2-12 Screw Hole Locations on the Mounting Bracket and Pole Clamp Bracket Assembly

1

2

3

4

3

3

281940

	1	Pole clamp bracket assembly		3	Bolt holes
	2	Access point support bolt		4	Mounting bracket
		(M8 flange nut not shown)
Step 9	Hand-tighten the bolts and the nut (do not overtighten).
Step 10	Adjust the top edge of the mounting bracket until it is horizontal and tighten the bolts and the flange nut
	(see Figure 2-12) to 13 to 15 ft lbs (17.6 to 20.3 Nm).
	Note		The mounting bracket can be adjusted up to 45o to compensate for tilted horizontal streetlight
			poles.
Step 11	Continue with Installing 1552E, 1552EU, or 1552I in the Mounting Bracket, page 2-23or Installing
	1552C or 1552CU in the Mounting Bracket, page 2-26, depending on what you purchased.

Installing 1552E, 1552EU, or 1552I in the Mounting Bracket

Step 1 Screw a M8 x16 bolt (without a flat or lock washer) in the top support bolt hole on each side of the access point (see Figure 2-13or Figure 2-14, depending on what you purchased). These bolts are supplied with pole mount kit. Do not screw the bolt all the way in. Leave a gap of approximately 0.25 inch (0.635 cm).

	Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
OL-24247-01		2-23