Cisco Systems AIRCAP1552HAK9, 1550 manual Mounting the Access Point, Installation Options

Chapter 2 Installing the Access Point

Mounting the Access Point

Step 3 When all bolts are hand-tightened, use a 13-mm closed-end wrench or socket to partially tighten the bolts in the tightening sequence shown in Figure 2-6. Tighten each bolt to 3 to 4 ft lbs (0.34 to 0.45 Nm).

Step 4 Repeat Step 3 using the same tightening sequence to fully tighten each bolt to 6 to 7 ft lbs (0.68 to 0.79 Nm).

Figure 2-6 Hinged Cover Bolt Tightening Sequence

13

5 6

255257

42

1 - 6

Tighten the bolts in the numeric order shown, starting with 1.

Mounting the Access Point

This section provides instructions for installing your access points. Personnel installing the access point must understand wireless access points and bridging techniques and grounding methods.

Caution All installation methods for mounting an access point on any wall surface is subject to the acceptance of local jurisdiction.

Installation Options

There are two optional installation kits:

•Strand mount kit—Used for cable strand installations

•Pole mount kit—Used for pole, wall, or streetlight installations

	Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
2-14	OL-24247-01