Cisco Systems 1552H, 1550 manual Unpacking the Access Point, Tools and Hardware, Package Contents

Chapter 2 Installing the Access Point

Unpacking the Access Point

Unpacking the Access Point

When you are unpacking the access point, do not remove the foam blocks attached to the antenna connectors. The foam protects the antenna connectors during installation.

To unpack the access point, follow these steps:

Step 1 Open the shipping container and carefully remove the contents.

Step 2 Return all packing materials to the shipping container, and save it.

Step 3 Ensure that all items listed in “Package Contents” are included in the shipment. If any item is damaged or missing, notify your authorized Cisco sales representative.

Package Contents

The typical access point package contains the following items:

•Access point

•Cisco product documentation and translated safety warnings

•Three liquid-tight adapters

•Two-pin DC power connector

•Ground lug (Panduit PLCD6-10A-L) and screws with lock washers

•Watertight cable glands for Power-over-Ethernet (PoE) ports (depending on the 1552 access point model, 2 or 3 cable glands are provided)

Tools and Hardware

The tools and hardware used to install the 1552 access point are described in:

•Optional Tools and Hardware, page 2-2

•Optional Tools and Hardware That You Supply, page 2-3

•Pole Installation Hardware and Tools, page 2-3

•Cable Strand Installation Hardware and Tools, page 2-4

Optional Tools and Hardware

The optional tools and hardware that can be obtained from Cisco are:

•Optional power injector (AIR-PWRINJ1500-2=)

•Optional AC power cord

–40-ft (12.2-m) power cord with North American plug (AIR-CORD-R3P-40NA=) for light pole installations in the US and Canada

–AC power cord, 40 ft (12.2 m) with European unterminated end (AIR-CORD-R3P-40UE=) for light pole installations outside of the US and Canada

Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide

2-2 OL-24247-01