Cisco Systems 1550, AIRCAP1552HAK9 manual Fiber-Optic Cable Components

Chapter 2 Installing the Access Point

Connecting a Fiber-Optic Cable to the Access Point

Step 1 Ensure that all power sources have been disconnected from the access point.

Warning This unit might have more than one power supply connection. All connections must be removed to de-energize the unit. Statement 1028

Note If your access point contains a backup battery pack, you must depress the reset button for 10 seconds or more (see the “Disabling Backup Battery Power” section on page 3-10).

Step 2 Open the hinged cover (see the “Opening the Access Point Hinged Cover” section on page 2-13for instructions).

Step 3 Place the two large reels with the small reels on top as shown in Figure 2-32.

Step 4 Align the screw holes in the large and small reels, and insert four attachment screws in each of the reel pairs. Tighten the screws to 3 to 4 in. lbs (0.34 to 0.45 Nm).

Step 5 Remove the plug from the end of the SFP module, and insert the module into the SFP receptacle (see Figure 2-32).

Figure 2-32 Fiber-Optic Cable Components

		1	Not used		4	Four screws for each reel assembly
2			SFP module slot		5	Fiber-optic connector plug
3			Fiber reels (large reel with small reel on top)
				Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
	OL-24247-01						2-43