Chapter 2 Installing the Access Point
Safety Information
Warning The AC power supply has double pole/neutral fusing. Statement 188
Warning Do not work on the system or connect or disconnect cables during periods of lightning activity. Statement 1001
Warning Class 1 laser product. Statement 1008
Warning There is the danger of explosion if the battery is replaced incorrectly. Replace the battery only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s instructions. Statement 1015
Warning A readily accessible
Warning To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord. Statement 1023
Warning This unit might have more than one power supply connection. All connections must be removed to
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement 1030
Warning Connect the unit only to DC power source that complies with the safety
Warning When installing or replacing the unit, the ground connection must always be made first and disconnected last. Statement 1046.
Warning Do not locate the antenna near overhead power lines or other electric light or power circuits, or where it can come into contact with such circuits. When installing the antenna, take extreme care not to come into contact with such circuits, because they may cause serious injury or death. For proper installation and grounding of the antenna, please refer to national and local codes (for example, U.S.:NFPA 70, National Electrical Code, Article 810, Canada: Canadian Electrical Code, Section 54). Statement 1052
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
|
| |
|
