Chapter 1 FAQs and Troubleshooting

Devices FAQs and Troubleshooting

a.Use the procedures in the configuration template instructions in the online help or the User Guide for the CiscoWorks Wireless LAN Solution Engine, 2.5 to create a template.

b.Enter the following custom values in the template: snmp-server view iso iso included

snmp-server community community_string view iso RO

c.Run a configuration job on the devices in the Misconfigured Devices group:

— Select the template created in the previous step.

—Either select the Misconfigured Devices group or the devices in the group.

—Schedule the job to run at the desired time.

d.After the configuration job finishes successfully, the dot11 mib fault will be cleared after the next discovery cycle. You can run a manual discovery immediately after the configuration job finishes; select Devices > Discover > Run Inventory > Run Now.

Perform the following steps on the WLSE:

a.If the device’s ISO community string has not been entered on the WLSE, select Devices > Discover > Device Credentials > SNMP Communities. Then, enter the same community strings that you configured on the devices in the previous procedure.

Otherwise, the devices will be placed back in the Misconfigured Devices group after the next discovery cycle.

b.Rediscover the devices by using them as seed devices in an immediate discovery. Select Devices > Discover > Run Inventory > Run Now. For more information on discovery, see the online help discovery section or the User Guide for the CiscoWorks Wireless LAN Solution Engine, Release 2.5.

FAQ and Troubleshooting Guide for the CiscoWorks Wireless LAN Solution Engine

1-17

Page 21
Image 21
Cisco Systems 2.5 manual Snmp-server community communitystring view iso RO