Cisco Systems 2.5 manual Down, the Ethernet

Chapter 2 Fault Descriptions

					Access Point Faults
Table 2-1 Access Point Faults (continued)
Fault Description	Type	Explanation	Related Setting	Recommended Action
HotStandBy is active	Non-IOS	The access point	Manage Fault	For non-IOS access
	and IOS	that is configured	Settings >	points:
		for hot standby has	Security	1.	Check the primary
		become active.	Policies >
					access point, the
			HotStandBy
		The following			Ethernet port, or the
			Status
		conditions could			Radio port to see why
		cause the hot			the hot standby access
		standby access			point has been
		point to become			activated.
		active: the primary		2.	Correct the condition.
		access point is
					For example, if the
		down, the Ethernet
					Radio Port on the
		port is down, or the
					formerly active access
		Radio port is down.
					point was in a disabled
		When this fault is			state, then enable it
		cleared, the			using the access point
		following message			GUI.
		displays:		3. Launch the GUI for
		HotStandBy is
					access point that is
		disabled.
					currently in Active
					Takeover mode.
				4. Select the Hot Standby
					section and click Start
					Hot Standby mode to
					reconfigure the access
					point to Hot Standby
					mode.

FAQ and Troubleshooting Guide for the CiscoWorks Wireless LAN Solution Engine

2-9