Cisco Systems 2.5 manual Utilization %

Chapter 2 Fault Descriptions

Access Point Faults

Table 2-1 Access Point Faults (continued)

Fault Description	Type	Explanation	Related Setting	Recommended Action
Retry Count rate is	Non-IOS	The fault threshold	Manage Fault	Verify that the fault
Overloaded number	and IOS	set for the	Settings >	threshold is set correctly.
per minute		overloaded state	Thresholds >	If the threshold is set
		has been exceeded.	Access Point >
				correctly, review your
			Max Retry
		When the fault is		network to determine the
			Counts
		cleared, the		action necessary to clear
		following message		the fault condition.
		displays: Retry
		Count rate is OK
RF bandwidth	Non-IOS	The fault threshold	Manage Fault	Verify that the fault
utilization is	and IOS	set for the degraded	Settings >	threshold is set correctly.
Degraded		state has been	Thresholds >	If the threshold is set
(utilization %)		exceeded.	Access Point >
				correctly, review your
			RF Port
		When the fault is		network to determine the
			Utilization
		cleared, the		action necessary to clear
		following message		the fault condition.
		displays: RF
		bandwidth
		utilization is OK
RF bandwidth	Non-IOS	The fault threshold	Manage Fault	Verify that the fault
utilization is	and IOS	set for the	Settings >	threshold is set correctly.
Overloaded		overloaded state	Thresholds >	If the threshold is set
(utilization %)		has been exceeded.	Access Point >
				correctly, review your
			RF Port
		When the fault is		network to determine the
			Utilization
		cleared, the		action necessary to clear
		following message		the fault condition.
		displays: RF
		bandwidth
		utilization is OK

FAQ and Troubleshooting Guide for the CiscoWorks Wireless LAN Solution Engine

2-14