Chapter 2 Fault Descriptions

Access Point Faults

Table 2-1 Access Point Faults (continued)

Fault Description

Type

Explanation

Related Setting Recommended Action

For IOS access points:

1. Check the primary access point, the Ethernet port, or the Radio port to see why the hot standby access point has been activated.

2. Correct the condition.

For example, if the Radio Port on the formerly active access point was in a disabled state, then enable it using the access point GUI.

3. Launch the GUI for access point that is currently in Active Takeover mode.

4. Select Hot Standby, click Disabled , then click Apply.

5. Click Enabled, then enter the Radio MAC address of Monitored Radio Port, leave the Polling interval and Timeout for Each Polling fields blank,.

6. Click Apply to reconfigure the access point to Hot Standby mode.

FAQ and Troubleshooting Guide for the CiscoWorks Wireless LAN Solution Engine

2-10

Page 60
Image 60
Cisco Systems 2.5 manual Related Setting Recommended Action