Chapter2 Fault Descriptions
Switch Faults
2-26
FAQ and Troubleshooting Guide for the CiscoWorks Wireless LAN Solution Engine
Port could not agree with
other end on duplex mode
The port could not
agree with the far end
on port duplex, and is
in disagree(3) mode.
When this fault has
been cleared, the
following message
displays: Port duplex
state is OK.
This fault is not
generated based on a
threshold or policy
violation.
Make sure the duplex
mode on both ends match.
Switch memory
utilization is Degraded
(utilization %)
The fault threshold
set for the degraded
state has been
exceeded.
When this fault has
been cleared, the
following message
displays: Switch
memory utilization is
Ok.
Manage Fault
Settings >
Thresholds >
Switch> Memory
Utilization
Verify that the fault
threshold is set correctly.
If the threshold is set
correctly, review your
network to determine the
action necessary to clear
the fault condition.
Switch memory
utilization is Overloaded
(utilization %)
The fault threshold
set for the overloaded
state has been
exceeded.
When this fault has
been cleared, the
following message
displays: Switch
memory utilization is
Ok.
Manage Fault
Settings >
Thresholds >
Switch> Memory
Utilization
Verify that the fault
threshold is set correctly.
If the threshold is set
correctly, review your
network to determine the
action necessary to clear
the fault condition.
Table2-4 Switch Faults (continued)
Fault Description Explanation Related Setting Recommended Action