Cisco Systems 2.5 manual Fault Description Type Explanation

Chapter 2 Fault Descriptions

Access Point Faults

Table 2-1 Access Point Faults (continued)

Fault Description	Type	Explanation	Related Setting	Recommended Action
Duplicate IP is found	Non-IOS	WLSE discovery	There is no	Do one of the following:
	and IOS	detects a second	setting	• Assign a new IP
		device with the	associated with
				address to the device.
		same IP address in	this fault.
				• If you have
		the network.
		When this fault is		substituted a device
				for the device with the
		cleared, the
				same IP, and want to
		following message
				continue to use that
		displays: Duplicate
				IP, then delete the
		IP is valid.
				original device, and
				run discovery again.
		When changing the		Delete the device, and run
		MAC address of the		discovery again.
		FastEthernet
		interface to the
		MAC address of a
		radio interface, the
		WLSE might detect
		the access point as a
		duplicate device.
		This is because
		during discovery,
		the uniqueness of
		the device is based
		on its FastEthernet
		MAC address.
EAP is disabled	Non-IOS	The EAP has been	Manage Fault	Log in to the access point
	and IOS	disabled.	Settings >	and enable the Network
		When this fault is	Security	EAP and Open
			Policies > EAP	authentication.
		cleared, the
			Enforced
		following message
		displays: EAP is
		enabled

FAQ and Troubleshooting Guide for the CiscoWorks Wireless LAN Solution Engine

2-6