Cisco Systems 2.5 manual Wlse-Wds

Chapter 2 Fault Descriptions

Access Point Faults

Table 2-1 Access Point Faults (continued)

Fault Description		Type	Explanation	Related Setting	Recommended Action
WDS appears down.		IOS	The WLSE failed to	Manage Fault	Check the network
			receive “keep	Settings >	connectivity, the WDS
			active” messages	Thresholds >	status, and the WLSE and
			from the WDS.	WDS >	WDS credentials.
			This happens when	WLSE-WDS
			the WDS is down or	Link Status
			when the network is
			down.
WEP Error is in		Non-IOS	The fault threshold	Manage Fault	Verify that the fault
Degraded state (error		and IOS	set for the degraded	Settings >	threshold is set correctly.
rate %)			state has been	Thresholds >	If the threshold is set
			exceeded.	Access Point >
					correctly, review your
				RF Port WEP
			When this fault has		network to determine the
				Errors
			been cleared, the		action necessary to clear
			following message		the fault condition.
			displays: WEP
			Error is in OK state
WEP Error is in		Non-IOS	The fault threshold	Manage Fault	Verify that the fault
Overloaded state		and IOS	set for the	Settings >	threshold is set correctly.
(error rate %)			overloaded state	Thresholds >	If the threshold is set
			has been exceeded.	Access Point >
					correctly, review your
				RF Port WEP
			When this fault has		network to determine the
				Errors
			been cleared, the		action necessary to clear
			following message		the fault condition.
			displays: WEP
			Error is in OK state
WEP is disabled		Non-IOS	WEP has been	Manage Fault	Log in to the access point
		and IOS	disabled.	Settings >	and enable WEP.
			When this fault has	Security
				Policies > WEP
			been cleared, the
				Enforced
			following message
			displays: WEP is
			enabled.
	FAQ and Troubleshooting Guide for the CiscoWorks Wireless LAN Solution Engine

2-18