Cisco Systems Monitoring RIP, Configuration Example for RIP

28-12
Cisco ASA 5500 Series Configuration Guide using ASDM
Chapter28 Configuring RIP
Monitoring RIP
•cleartext to use cleartext for RIP message authentication (not recommended).
Step9 Click Apply.
Restarting the RIP Process
To remove the entire RIP configuration, perform the following steps:
Step1 In the main ASDM window, choose Configuration > Device Setup > Routing > RIP > Setup.
Step2 Click Reset.
Monitoring RIP
To monitor or display various RIP routing statistics in ASDM, perform the following steps:
Step1 In the main ASDM window, choose Monitoring > Routing > Routes.
Step2 From this pane, you can choose to monitor the following:
•IPv4
•IPv6
•Both
Configuration Example for RIP
The following example shows how to enable and configure RIP with various optional processes:
Step1 In the main ASDM window, choose Configuration > Device Setup > Routing > RIP > Setup.
Step2 Check the Enable RIP routing check box and click Apply.
Step3 Check the Enable default information originate check box.
For more information about defining a route map, see the “Defining a Route Map” section on page26-4.
Step4 Check the Enable RIP version check box and choose Vers ion 1.
Step5 In the Networks area, enter 225.25.24.225 in the IP Network to Add field.
Step6 In the Passive Interface area, click the check box next to the interface that you want to be passive in the
Passive Interfaces table.
Step7 Click Apply.
Step8 Choose Configuration > Device Setup > Routing > RIP > Redistribution.
Step9 Click Edit.