5-20
Cisco ME 3400 EthernetAccess Switch SoftwareConfiguration Guide
78-17058-01
Chapter5 Administering the Switch
Managing the MAC Address Table
These sections contain this configuration information:
•Building the Address Table, page 5-20
•MAC Addresses and VLANs, page 5-20
•Default MAC Address Table Configuration, page 5-21
•Changing the Address Aging Time, page 5-21
•Removing Dynamic Address Entries, page 5-22
•Configuring MAC Address Notification Traps, page 5-22
•Adding and Removing Static Address Entries, page 5-24
•Configuring Unicast MAC Address Filtering, page 5-25
•Disabling MAC Address Learning on a VLAN, page 5-26
•Displaying Address Table Entries, page 5-28
Building the Address Table
With multiple MAC addresses supported on all ports, you can connect any port on th e sw itc h t o
individual workstations, repeaters, switches, routers, or other network devices. The switch provides
dynamic addressing by learning the source address of packets it receives on each port and adding the
address and its associated port number to the address table. As stations are added or removed from the
network, the switch updates the address table, adding new dynamic addresses and aging out those that
are not in use.
The aging interval is globally configured. However, the switch maintains an address table for each
VLAN, and STP can accelerate the aging interval on a per-VLAN basis.
The switch sends packets between any combination of ports, based on the destination address of the
received packet. Using the MAC address table, the switch forwards the packet o nly to the port as sociated
with the destination address. If the destination address is on the port that sent the packet, the packet is
filtered and not forwarded. The switch always uses the store-and-forward method: complete packets are
stored and checked for errors before transmission.
MAC Addresses and VLANs
All addresses are associated with a VLAN. An address can exist in more than one VLAN and have
different destinations in each. Unicast addresses, for example, could be forwarded to port 1 in VLAN 1
and ports 1, 9, and 10 in VLAN 5.
Each VLAN maintains its own logical address table. A known address i n one V LA N i s u nknown in
another until it is learned or statically associated with a port in the other VLAN.
When private VLANs are configured, address learning depends on the type of MAC addre ss:
•Dynamic MAC addresses learned in one VLAN of a private VLAN are replicated in the associated
VLANs. For example, a MAC address learned in a private-VLAN secondary VLAN is replicated in
the primary VLAN.
•Static MAC addresses configured in a primary or secondary VLAN are not replicated in the
associated VLANs. When you configure a static MAC addres s in a private VLA N pri m ary o r
secondary VLAN, you should also configure the same static MAC address in all associated VLANs.
For more information about private VLANs, see Chapter12, “Configuring Private VLANs.”